Brainboxes Ethernet to DIO 8 Digital Inputs and 8 Digital Outputs

• Manufacturer code: ED-588
• Humidity: 5 to 95% (non-condensing)
• Features: Over temperature shutdown :1750C typical 150 0 C min
• Ethernet port: 10/100Mhz autosensing,
• Operating Temperature: -30oC to +80oC, -22ºF to +176ºF
• Storage Temperature: -40°C to 85°C (-40°F to 185°F)
• Max. Power Consumption: 2.5 W
• Network Protocols: HTTP
• Input Channels: 8 non-isolated input channels
• NPN/PNP: One jumper configures all inputs as either pull up for NPN, active low, type sensors or pull down for PNP, active high, type sensors
• Logic Level 0: 0V to +1V
• Logic Level 1: +3.5V to +30V
• Latched Inputs: Triggered by user programmable positive or negative edges, stays true until acknowledged
• Counter Inputs: User programmable- counts positive or negative transitions 0-65335
• Output Channels: 8 non-isolated output channels
• Maximum output current: Sinks up to 1 Amp per pin, 40V max load Max combined load 4.0 Amps per ED device
• Maximum output load Voltage: 40V
• ESD Protection: 16kV
• Webserver Interface: Set Power on digital output value
• Programming Interface: Software drivers give local COM Port interface for configuration
• Utility Programs: configure IP address
• Power up: On power up all outputs go to user programmable power on known good state
• Watchdog coms link: On loss of communications link all outputs go to a user programmable watchdog comms known good state.
• Watchdog hardware timer: If the firmware does not refresh the watchdog timer within a predetermined interval then all outputs go to a user programmable watchdog hardware good
• E-Stop function: When a user programmable input transitions to a preconfigured high or low state then all outputs go to a user programmable E-Stop known good state
• Protection: 1,500Volts magnetic isolation between I/O ports and network
• Connection to Network: Ethernet 10BaseT / 100BaseTX
• Screw Terminals: 3.5mm pitch, #22 - #14, 0.5mm2 -2.5mm 2 pin power supply