(image for) Brainboxes Ethernet to DIO 8 Digital Inputs and 8 Digital Outputs
  • In Stock:  10

Brainboxes Ethernet to DIO 8 Digital Inputs and 8 Digital Outputs

£303.82
Product Overview Ethernet to DIO Ethernet to DIO device: 8 non-isolated digital input channels and 8 digital output channels. Outputs each group of 4 lines has its own common rail. Powerful ARM 80 MHz, 32 Bit CPU. Offers robust and intelligent 'control side' devices that provide the interface...

Connection to Network

Ethernet 10BaseT / 100BaseTX


Counter Inputs

User programmable- counts positive or negative transitions 0-65335


E-Stop function

When a user programmable input transitions to a preconfigured high or low state then all outputs go to a user programmable E-Stop known good state


ESD Protection

16kV


Ethernet port

1 x RJ45 jack
10/100Mhz autosensing,


Features

Open drain output
Over temperature shutdown :1750C typical 150 0 C min
protected MosFET intelligent short circuit protec- tion up to 36V


Humidity

5 to 95% (non-condensing)


Input Channels

8 non-isolated input channels


Latched Inputs

Triggered by user programmable positive or negative edges, stays true until acknowledged


Logic Level 0

0V to +1V


Logic Level 1

+3.5V to +30V


Manufacturer code

ED-588


Max. Power Consumption

2.5 W


Maximum output current

Sinks up to 1 Amp per pin, 40V max load Max combined load 4.0 Amps per ED device


Maximum output load Voltage

40V


Network Protocols

DHCP
HTTP
ICMP
IP
TCP
Telnet


NPN/PNP

One jumper configures all inputs as either pull up for NPN, active low, type sensors or pull down for PNP, active high, type sensors


Operating Temperature

-30oC to +80oC, -22ºF to +176ºF


Output Channels

8 non-isolated output channels


Power up

On power up all outputs go to user programmable power on known good state


Programming Interface

just open a TCP connection and send simple ASCII commands.
No device driver needed
Software drivers give local COM Port interface for configuration


Protection

1,500Volts magnetic isolation between I/O ports and network


Screw Terminals

3.5mm pitch, #22 - #14, 0.5mm2 -2.5mm 2 pin power supply


Storage Temperature

-40°C to 85°C (-40°F to 185°F)


Utility Programs

configure IP address
Find device


Watchdog coms link

On loss of communications link all outputs go to a user programmable watchdog comms known good state.


Watchdog hardware timer

If the firmware does not refresh the watchdog timer within a predetermined interval then all outputs go to a user programmable watchdog hardware good


Webserver Interface

Configure IP address
monitor state of i/o lines,
Set Power on digital output value
set the Watchdog Timers Output Reset Value,


Add to Cart:
  • Manufactured by: Brainboxes
  • This product was added to our catalog on Monday 30 November, 2043.